WithinReach
Clamp-on storage for wheelchairs, printed instead of installed.
Prototype

Not public yet

A single clamp grips a wheelchair frame tube and carries a short dovetail rail. Bins, a bottle holder, and hooks slide on, click into place, and lift off with one hand—no pinching, twisting, or tiny latches.
Every part is parametric, so the same design fits tubes from 12 to 40 mm and tilts anywhere from −60° to 90°. It's designed around one rider's chair and the two or three things they reach for most.
The idea of one mount with interchangeable modules came from MakerWorld's WithinReach design brief, written by the Emerging Tech Lab at Rancho Los Amigos.
- Status
- Prototype
- Built with
- OpenSCAD
- 3D printing
- Where to find it
- Not public yet
- Notes
- Checked in software across 22 configurations
- Not printed yet
- The first Fulmerica project you can hold